Refco TAP Guía De Instalación Y Funcionamiento página 15

Instruction Manual TAP / Temperature And Pressure Gauge
TAP Pressure Gauge
Set-up TAP Insert 4 x 1.5 V (AAA) batteries in the battery compart-
Switch on
Set TAP ID - Press [MENU] butto ≥ 1 sec. to activate selection
Set
refrigerant
The TAP must not be used for a
The TAP should not be expose
ment on the back side of the TAP.
Remove refrigerants from the T
Ensure the batteries are inserted observing the correct
polarities. Do not leave dead batteries in the battery
Purpose and use
compartment. If you will not be using the TAP pressure
gauge for a long period of time, remove the batteries
from the battery compartment.
The TAP has been developed for me
- Press [ON] button to switch on device.
and stationary refrigeration equipmen
After start, REFCO-logo appears on display.
TAP is only designed for temporary m
measurement unit.
mode.
TAP ID menu is selected.
- Press [SET] button ≥ 1 sec. to enter TAP ID menu.
Scope of delivery
- Choose a TAP ID number by pressing [UP] or
[DOWN] button < 1 sec.
- Press [SET] button ≥ 1 sec. to confirm selected ID.
Information about the various models
- Press [MENU] button ≥ 1 sec. to return to main display.
REFCO catalogue or at
Note:
Number for P1 to P6 is always concurrent with the TAP
Play Store.
number.
To change current refrigerant setting:
Technical Data
- Press [MENU] button ≥ 1 sec. to activate selection
mode.
- Press [DOWN] button < 1 sec. to scroll down to the
Temperature clamp
refrigerant menu.
- Press [SET] button ≥ 1 sec. to enter refrigerant
menu.
Property
- Press [UP] or [DOWN] button ≥ 1 sec. to scroll to the
Thermocouple:
desired field refrigerant type entry.
- Press [SET] button ≥ 1 sec. to confirm.
Temperature range:
- Press [MENU] button ≥ 1 sec. to return to main display.
Accuracy of
Note:
measurement:
The first 6 refrigerants can be favorites.
Following are all known refrigerants from library.
Resolution:
Note on R000: Temperature units:
Additional function to select from table of refrige-
Pipe diameters of:
rant: If use entry " R000" it means " Pressure only". No
readouts from chart. It gives the possibility to measure
Ambient temperature:
only pressure and temperature without any refrigerant
chart temperatures shown. Storage temperature:
Power supply:
English
www.refco.c
Value
K-type
-40 °C to
+/- 1 °C /
0.1 °C / 0.
°C / °F
6 mm to 4
0 °C to +5
- 20 °C to
3 x 1.5 V
15