Refco TAP Guía De Instalación Y Funcionamiento página 19

Instruction Manual TAP / Temperature And Pressure Gauge
Maintenance
• A visual inspection of the connections and hoses must be
carried out before each use to check for mechanical damage.
• Do not use aggressive cleaning agents or solvents to clean the
device. Gentle household cleaners and soapy water should be
Instruction Manual TAP / Temperature And Press
used instead.
• TAP seals are subject to mechanical and age-related wear. The-
refore, the TAP should be regularly tested by the user for leaks.
Resetting pressure sensor on TAP pressure gauge
The TAP must not be used for anything other th
The TAP pressure sensor can be reset in order to avoid incorrect mea-
surement values.
The TAP should not be exposed to moisture or
P-Zero
Remove refrigerants from the TAP and the hos
To obtain a correct measurement value on the display, the
TAP should not be reset when pressurised.
1. Ensure TAP pressure gauge is switched on.
Purpose and use
2. Press [MENU] button ≥ 1 sec. to activate selection mode.
3. Press [UP] button < 1 sec. to scroll up to the setting field .
4. Press [SET] button ≥ 1 sec. to enter settings menu.
The TAP has been developed for measuring pressur
5. Press [UP] or [DOWN] button < 1 sec. to scroll to the
and stationary refrigeration equipment.
"P-Zero"field.
6. Enter "P-Zero" by pressing [SET] button ≥ 1 sec.
TAP is only designed for temporary measurement, d
7. Display shows 0.0psi
measurement unit.
8. Press [SET] button ≥ 1 sec. for confirmation.
9. Display shows setting menu.
1 0. Press [MENU] button ≥ 1 sec. to quit.
Scope of delivery
Updating of refrigerants on TAP pressure gauge via Micro USB
Information about the various models and variations
The TAP pressure gauge supports updates of refrigerant data via
REFCO catalogue or at www.refco.ch. The REFCO
Micro USB. The latest refrigerant charts can be found at www.refco.ch
Play Store.
Updating refrigerants
1. Ensure TAP pressure gauge is switched on.
2. Press [MENU] button ≥ 1 sec. to activate selection mode.
Technical Data
3. Press [UP] button < 1 sec. to scroll up to the setting field
4. Press [SET] button ≥ 1 sec. to enter settings menu.
5. Press [UP] or [DOWN] button < 1 sec. to scroll to the
Temperature clamp
"SD Mode"field.
6. Enter "SD Mode" , select "USB MSC".
Property
7. Connect TAP to computer by USB connection; the device shown
on computer.
Thermocouple:
8. Copy the file "Refriger .bin" to the folder "Refriger" which is
Temperature range:
under the device.
Accuracy of
9. Disconnect the TAP from computer.
10. Enter "SD Mode" , select "SD FAFS"
measurement:
11. Enter "Update" (MENU) to update the refrigerant data.
Resolution:
Temperature units:
Pipe diameters of:
Value
K-type
-40 °C to +125 °C / -40 °F
+/- 1 °C / +/- 1.8 °F
0.1 °C / 0.1 °F
°C / °F
6 mm to 41 mm / ¼" to 1-
English
.
19