Refco TAP Guía De Instalación Y Funcionamiento página 17

Instruction Manual TAP / Temperature And Pressure Gauge
Pairing
Change
Settings
- Ensure the distance between the devices is less
than 5 meters.
- Ensure TAP CLAMP(S) which shall be paired with TAP
pressure gauge are switched on.
- Ensure TAP pressures gauge is on.
- Set sliding switch on device to "online".
- Press [MENU] button ≥ 1 sec. on TAP pressure
gauge to activate selection mode.
- Press [DOWN] button < 1 sec. of TAP pressure
gauge to scroll down to the field "T".
- Press [SET] button ≥ 1 sec. to start scanning.
Display of TAP pressure gauge shows "Scan..."
Note:
If no device can be found, " No Signal" appears on
display before return to menu.
- If device be found, display shows a list of found TAP
CLAMP ID(s).
- Select desired TAP CLAMP ID by pressing [UP] or
[DOWN] button < 1 sec.
- Press [SET] button ≥ 1 sec. to start pairing.
During pairing procedure, display shows "Connect...".
If pairing was successful, display shows "END".
Paired TAP CLAMP is recognised on TAP display with
T and relevant number (1 to 6).
- If pairing was not successful, display shows
"ERROR". If this happens, repeat steps above and
try again.
- Press [MENU] button ≥ 1 sec. to activate selection
mode.
- Press [UP] button < 1 sec. to scroll up to the setting
field .
- Press [SET] button ≥ 1 sec. to enter settings menu.
- Press [UP] or [DOWN] button < 1 sec. to scroll to the
desired field.
Available fields:
Auto Off
Update
Version
SD Mode
P-Zero
- Press [SET] button ≥ 1 sec. to confirm.
Auto Off
- Press [UP] or [DOWN] button < 1 sec. to choose the
auto shutoff option. (10 min. / 20 min. / Off)
- Press [SET] button ≥ 1 sec. to confirm.
English
17