Refco TAP Guía De Instalación Y Funcionamiento página 5

Instruction Manual TAP / Temperature And Pressure Gauge
CE/FCC Conform
CE/FCC Notice
CE:
This device meets the norm EN300 440.
FCC:
This device meets the requirements in accordance to part 15 of the
FCC. Operation occurs under the following terms:
(1). This device does not produce any harmful interference with
reception
(2). This device must tolerate high-frequency radiation, inclusive ra-
diation which could result in undesired reactions.
Note: The grantee is not responsible for any changes or modifica-
tions not expressly approved by the party responsible for complian-
ce. Such modifications could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to rovide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interfe-
rence to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure require-
ment. The device can be used in portable exposure condition without
restriction.
- TAP is available in a suitable case either as single or double set.
CE/FCC Conform
CE/FCC Notice
CE:
This device meets the norm EN300 440.
FCC:
This device meets the requirements in accordance to part 15 of the F
occurs under the following terms:
(1). This device does not produce any harmful interference with recep
(2). This device must tolerate high-frequency radiation, inclusive radia
result in undesired reactions.
English
5