Descargar Imprimir esta página

SWM SIX6 500 Manual De Instrucciones página 41

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

BRAKE PAD WEAR CHECK
Check the state of wear of the front brake pads (1)
and the rear brake pads (2)
- The pads have a groove (3) that indicates wear;
when the groove has almost disappeared, the pair
of brake pads have to be replaced.
CAUTION
a a
Contact an SWM dealer to have the
brake pads replaced.
a
WARNING
After the brake pads have been
replaced, ride carefully and brake
gradually in order to allow the brake
pads to properly run in/couple to the
relative discs.
front pad
Rear pad
PAD CLEANING
Make sure that there are no traces of brake fluid or
oil on the pads or discs. Use alcohol to clean the pads
or discs from any traces of fluid or oil.
If the pads cannot be cleaned properly, replace them.
PAD INSTALLATION
Refit the pads following the removal procedure in
reverse order.
a
WARNING
Do not ride the motorcycle until the
brake lever or pedal is fully effective.
"Pump" the brake lever or pedal until
the pads are against the discs. The
brake will not operate when the lever or
pedal is activated for the first time.
DISC CLEANING
A poor braking efficiency can also be caused by the
presence of oil on the disc. Oil or grease on the disc
can be removed using a high flammability index
solvent such as acetone or similar products.
SIX DAYS
41 -
EN

Publicidad

loading