Descargar Imprimir esta página

Ducati DRTL 2100 Manual De Instrucciones página 34

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Owner´s manual
2. OPERATION AND USE OF TILLER
1. Assembly
1. Unpacking assembly
1.1 Take out rotary tiller and accessories.
1.2 Fix the body of rotary tiller, install walking wheels, then use pin 8×40 and clip to fix them.
Install rear wheels in the appropriate height, then use lock bolt to fix it.
1.3 Tilling/ditching blades installation: install tilling blades or ditching blades on both sides of
output shaft, edge towards forward, and then use pin M8×40 and clip to fix it.
1.4 Mud fender (or narrow mud fender) and side mud fender installation:
Install left and right mud fenders on the tiller, fixing with bolt M6×12 (8 pcs) and locknut M6 (8 pcs),
and screw up by spanner. The adjustable part of mud fender place is as the picture. Then install
side mud fender on both sides and screw up small handles.
1.5 Handle bar installation: assemble handle bar components on tiller. The handle bar frame
position is symmetrical accordingly for the tiller, then use the locked pin to fix the frame.
2. Installation and adjustment of cables
2.1 Adjustment of clutch cable (Fif. 1)
A) Unlock nuts on the screw rod.
B) Instantaneously rotate the screw rod to show the shortest part of the handle bar.
C) Connect the clutch cable head into clutch plug behind the gear box assy, thread the cable
into axis pin M6×20, and fix with jump ring.
D) Properly pull down the clutch cable and fix the clutch cable head to handle bar bottom.
E) Rotate out the screw rod and clip
it repeatedly, unlock the clutch
handlebar until spring force of clutch
can reset the bar, finally fasten the
nuts.
2.2 Adjustment of oil throttle cable.(Fig. 2)
A) Screw oil throttle switch to the minimum
scale.
B) Thread the steel wire-rope into the oil
throttle, the pole and plug of regulation
panel of gasoline engine.
C) Fasten the steel wire-rope and fix the
screw.
D) Adjust the oil throttle switch repeatedly
until the throttle bar of the regulation panel
can be in the fastest or slowest position.
34
Fig. 1
Fig. 2

Publicidad

loading