Publicidad
Idiomas disponibles
Idiomas disponibles
2.Common faults and removing ways table of tiller
Phenomenon
The clutch can not be opened
or closed.
Belt becomes tight, and tills
powerlessly
Gear isn't in the correct position
Gear leaves the correct
position
There is oil leakage of gear box
or tilling box
Incorrect sound of gear box or
tilling box
Engine support broke
Rotary blades(Ditching blades)
rub tilling box Rotary blades are
broken
Rotary blades (Ditching blades)
Don't work
There is dark smoke from engine
Reason
Belt is too tight
Control wheel presses tightly belt
in loose situation
Belt is too loose
Control wheel don't touch belt in
tight situation
Don't fill steel ball, spring
or steel ball appears not
enough
Shift axis exists problems
Steel balls appear not
enough, spring is powerless
Oil leaks from seal
Near bolts or nuts loosen
The combined facet of the alumi-
num gasket and box isn't flat
Don't add paper gasket
Added oil over the level
Changed gear is not in the
correct position
Chain broke
Gear interferes gear box each
other
Don't add oil
Welding problem
Don't put pin and clip
Rotary blades problem
Assembling direction of rotary
blades is wrong
Assembling of left or right rotary
blades is same
Engine head is covered by oil.
English
Owner´s manual
Solution
Adjust the engine to make belt's
loose situation meet the manual
instruction
Adjust clutch cable to make control
wheel down and touch belt
Adjust the engine to make belt's
loose situation meet the manual
instruction
Adjust clutch cable to make control
wheel up and touch belt
Change
Change
Change spring
Change
Screw tightly or change
Burnish flatly, or use sealant
Add paper gasket
Release oil to the level
Make changed gear is in the
correct position
Change
Change gear box, tilling box or
gear
Add oil
Weld again or change
Add pin and clip
Change
All blades face to the forward direc-
tion of the machine
Change one of the both
Work longer, the combined oil is
burned. Decrease tilling angle of
inclination of the tiller.
47
Publicidad
