Publicidad
Idiomas disponibles
Idiomas disponibles
ORBITWIN SW
8.
SeTUP AND MOUNTING
8.1
Procedure
NOTe!
WARNING!
Carry out setting up and mounting in the following order:
1. Mechanically connect the ORBITWIN SW with the power supply.
2. Connect the ORBITWIN SW and the power supply via the connecting lines and hoses.
3. Connect the torch to the ORBITWIN SW output channel.
4. Connect the gas bottle for the permanent gas function.
8.2
Mechanically connect the ORBITWIN SW with the power supply
CAUTION!
1. Place the power supply on the ORBITWIN SW.
2. Connect the ORBITWIN SW and power supply with each
other by means of the connection pieces (1) and screws (2).
[REV. 20230213] OW_ORBITWIN_SW_BA_853060201_01__INH-02_EN
Observe the operating instructions of the ORBIMAT power supply and the weld heads!
Electrical hazards through contact.
X Before connecting the ORBITWIN SW with the weld power supply, unplug the power
plug of the power supply.
Hands and fingers can be caught in and crushed while placing the power supply on the
ORBITWIN.
X To mount the switching device and power supply, place the switching device on a stable
base.
X Carry out placement of the power supply on the switching device with at least 2 persons.
X Place the overall system (power supply and switching device) only on stable bases.
X When lifting the overall system (power supply and switching device) do not exceed the
permissible total weight of 25 kg for men and 15 kg for women.
X Wear safety shoes.
Setup and mounting
2
1
2
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
43
Publicidad
