Publicidad
Idiomas disponibles
Idiomas disponibles
ORBITWIN SW
9.
OPeRATION
NOTe!
9.1
Switching between the output channels
Switching between the output channels can be carried out in two ways:
1. Switchover directly by pressing the switchover keys integrated in the ORBITWIN SW
or
2. Switchover by pressing and key of the control panel integrated in the weld torch.
The respectively active output channel is signaled by a blue signal light integrated in the switchover keys of the ORBITWIN SW
output channel and is indicated in the power supply software in the information box at the bottom right.
ORBITWIN channel 1 ACTIVE
During the welding process switching over between the channels is not possible. The respective switchover keys are locked.
9.2
Channeldependent allocation of welding procedures
Welding procedures that are independent of each other can be assigned to both output channels.
The assigned welding procedures remain loaded in the background.
At a channel switchover the power supply software switches over automatically to the welding procedure assigned to the channel.
1. Switchover to the desired output channel.
2. Create a welding procedure or call it up from an internal or external memory.
X If applicable, repeat for the second channel.
Read the operating instructions of the power supply for information about creating and loading welding procedures.
[REV. 20230213] OW_ORBITWIN_SW_BA_853060201_01__INH-02_EN
Observe the operating instructions of the ORBIMAT power supply and the weld heads!
ORBITWIN channel 2 ACTIVE
Operation
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
47
Publicidad
