Publicidad
Idiomas disponibles
Idiomas disponibles
To change the engine oil (with or wi-
thout oil filter cartridge replacement)
1. Place the vehicle on a flat surface and
keep it upright.
2. Start the engine, warm it up for several
minutes, and then turn it off.
3. Place a suitable container under the en-
gine to collect the used oil.
4. Remove the engine oil filler cap, the en-
gine oil drain bolt and its gasket to drain
the oil from the crankcase.
1. Engine oil drain bolt
NOTE
Skip steps 5–7 if the oil filter cartridge is
not being replaced.
5. Remove the oil filter cartridge with an
oil filter wrench.
1. Oil filter cartridge
1
6. Apply a thin coat of clean engine oil to
the O-ring of the new oil filter cartridge.
6 - 11
Periodic maintenance and adjustment
1
NOTE
Make sure that the O-ring is properly se-
ated.
7. Install the new oil filter cartridge with
an oil filter wrench, and then tighten it to
the specified torque with a torque wren-
ch.
8. Install the engine oil drain bolt and its
new gasket, and then tighten the bolt to
the specified torque.
Tightening torque:
Oil filter cartridge:
15 N·m
EN
6
Publicidad
