Publicidad
Idiomas disponibles
Idiomas disponibles
To perform FLUSH INSTALLATION, drill the top and mill the
worktop along the edge of the installation hole, respecting the
measurements indicated:
Fig. 13 - 60cm worktop
R 4
Fig. 14 - 80cm worktop
R 4
Installation is under the sole responsibility of the specialists.
The installer must comply with the legislation and standards in force
in his/her country of origin. To protect the cut edge of the cabinet,
apply a coat of special paint or sealant. Special care must be
taken when applying the adhesive gasket supplied with the hob
to prevent leaks in the supporting cabinet. This gasket ensures a
proper seal when used in combination with smooth work surfaces.
How to attach the gasket:
The gasket supplied with the hob prevents all liquid ingress into
the cabinet. It must be installed carefully in accordance with the
following drawing.
Attach the gasket (2) two millimetres from the outer edge of the
glass after removing the protective film (3).
Assembly - installation:
• Make sure that there is a distance of 50 mm between the hob
and the wall or sides.
• Ideally, the hob should be installed with plenty of space on both
sides. There could be a wall at the back and high units or a
wall on one side. On the other side, however, no unit or divider
should be higher than the hob.
• The cabinet or stand in which the hob is to be installed, as well
as the edges of the cabinet, the laminate coatings and the glue
used to fix them, must be able to withstand temperatures of up
to 100°C.
• Do not install the hob above a non-ventilated oven or dishwasher.
Secure the air connection (Fig. 15) on the extractor fan outlet with
the two screws provided.
Fig. 15
Set down the hob (Fig. 16).
Fig. 16
Adequate ventilation must be ensured at the front and rear of the
cabinet so that air can circulate through the various air intakes as
indicated below in the figures:
EN
9
Publicidad
