Publicidad
Idiomas disponibles
Idiomas disponibles
USER MENU
From the User Menu, you can change certain control panel
functions such as brightness, key sound volume, information sound
volume, control panel lighting, timer animation, etc. To access the
User Menu, the control panel (hob control display) must be in
standby mode (off).
Accessing the User Menu:
• Touch ON/OFF to switch on the Control Panel, then tap ON/
OFF again within 3 seconds to switch off.
• The || (Pause) key starts pulsing for up to 60 seconds (if no
action is taken, the menu entry attempt is automatically exited
after these 60 seconds).
• Press the || (Pause) key without releasing it.
• Press the display of each cooking zone clockwise as shown in
Fig. 27, again without releasing the Pause key, starting from the
front left cooking zone display 2FL (1-2-3-4).
Fig. 27
Left Rear
Meaning
Display (2RL)
U0
Power Adjustment (1.4-7.4)
(if default setting C8=0)
(step 0.1 kW)
E.g. Power Adjustment (1.4-3.7)
(if modified with setting C8=5)
U1
Filter setting:
Grease or carbon filter with or without
a 5-minute after-run fan (after-run fan is
extractor operation at level 1 after you
have switched off the hob because you
have finished cooking)
U2
Volume for button tones
• Each key press will be confirmed by an acoustic signal (beep).
• Release the || (Pause) key that has pulsed.
• The user menu is active.
• The left rear cooking zone display (2RL) intermittently shows
"U0" ("U" and "0"). Select the menu item you wish to view/
change using the slider (4) as summarised in the table Fig. 27.
For example, to go to U4 (display brightness), press on the 2RL
display and with the touch slider select level 4 (the third slider
bar from the left)
U4 now flashes intermittently.
• At this point, select the front left display (2FL), where the set value
and any possibilities are displayed.
In the example of the brightness setting, after selecting the front
left display (2FL), all bars up to 9 will appear on the slider
and the display (2FL) will show the number with a permitted
value, in this case from 0 to 9 (in other cases there may be
fewer values, e.g. in U3 there are only values from 0 to 3)
Then the front left cooking zone display (2FL) will show the
selected value of the respective selected element; you can then
change the value by touching the slider.
Exiting the User Menu:
• Exit without saving: Touch the || (Pause) key. All changes are
deleted.
• Exiting with Save Settings: Touch the power ON/OFF key for 2
seconds. Changes are saved.
Note: The user menu closes automatically if no operations are
performed for 1 minute.
Overview of user menu items
The following table provides an overview of the user menu items:
Variable
Front Left Display
(2FL) (Value Format)
Yes
e.g. 7.4 (default)
e.g. 3.7 (if service menu
setting C8 = 5)
Yes
0,1,2,3
(U1 DEFAULT= 0)
Yes
0,1,2,3
(U2 DEFAULT= 3)
.
.
Note
Filter:
0-grease filter + after-run fan 5 min. (G)
1-carbon filter + after-run fan 5 min. (F)
2-grease filter without after-run fan (G)
3-carbon filter without after-run fan (F)
Volume setting for button tones:
0: no button tones
1: minimum volume
2: half volume
3: maximum volume
EN
17
Publicidad
