Publicidad
Idiomas disponibles
Idiomas disponibles
6.3 Charging in Authentication mode (Autostart disabled)
If the Authentication Operating Mode is configured, the charging session can be
authorized in two modes: with an associated RFID card or via the app.
•
The display of the wallbox will show "authorize with the app or the rfid
card" when it is ready for charging.
•
Insert the plug of the charging cable into the socket on the device, until it
is fully engaged.
•
Insert the plug of the Type 2 cable in the charge port of the electric vehicle.
•
Pass the associated RFID card over the
connected, start remotely via app.
•
Charge the vehicle.
•
When charging is complete or the charging process needs to be stopped,
there are three possible ways to stop the charging session:
•
From the vehicle (e.g. unlocking the doors), then unplug the connector
from the vehicle and from
•
Pass the associated RFID card over the reader on eProWallbox, the
session will stop and the socket in use will be unlocked.
•
From
from the vehicle and from eProWallbox.
•
The product returns to its initial state, ready for a new charging session.
CAUTION
At the end of the charging sessions, unplug the charging cable from
both the appliance and the vehicle and store it in a safe place.
NOTICE
It is possible to stop the charging session via the eSolutions Charging
app only when eProWallbox is connected, so when Standalone mode
is disabled (refer to chapter 5.2 Operating modes).
eSolutions Charging
Devices
Via Corradori 22 - Milano
00:02:30
:02:30
View more
CHARGING
DELAY
DELAY
26
eProWallbox
eProWallbox
app, press STOP and remove the connector
S TOP
S
STOP
Use r Man ual
reader , or if
Publicidad
