Descargar Imprimir esta página

Angelo Po 1S1BR1G Manual De Uso página 49

Sartén de gas

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

FAULT
– When washing the appliance, do not point
pressurised water jets at internal parts .
Since the appliance is used for preparing foods
for human consumption, special care must be
paid to everything relating to hygiene, and the
appliance and the entire surrounding environ-
ment must constantly be kept clean .
WARNING:
cleaning operation, always turn off the gas
supply tap, cut off the electricity supply
using the master switch and allow the
appliance to cool .
The following precautions are also important .
WARNING: When using detergents,
rubber gloves, protective mask and safety
goggles must be worn in accordance with the
relevant safety regulations .
– Clean all parts of the appliance with warm
water, food-approved detergents and non-
abrasive materials only .
– Thoroughly clean all parts which come into
direct or indirect contact with foods and all
surrounding areas .
The appliance has been tested before being
put into service . The information provided be-
low is intended to assist in the identification
and correction of any anomalies and malfunc-
tions which might occur during use .
The user can solve some of these problems
himself, but for others specific technical knowl-
edge or skill is required, and so they must only
be carried out by qualified staff with recog-
Faults
Smell of gas .
The pilot light goes out .
3413920_ut_GB
Before
starting
FAULT
TROUBLESHOOTING
Causes
Occasional leak because
flame has gone out .
The thermocouple has not
warmed up enough .
– After use, clean the accessories with a sui-
table grease-remover product . If possible,
wash in the dishwasher .
WARNING: Never use products con-
taining substances that are harmful or dan-
gerous for people's health (solvents, fuels,
etc .) .
any
– Rinse surfaces with drinking water and dry .
– Pressurised water jets may only be used on
external parts .
– Take special care not to damage stainless
steel surfaces . In particular, avoid the use of
corrosive products and do not use abrasive
materials or sharp tools .
– Remove food residues immediately before
they set .
– Remove the limescale deposits which may
form on some of the appliance's surfaces .
nised experience acquired in the specific sector
of operation .
NOTE:
For any need, please contact Angelo Po's
agents or headquarters, which can be found
in the contacts section of the website www .
angelopo .com .
Turn off the gas supply tap and
Make more attempts to light the
ENGLISH
Remedies
ventilate the room .
flame .
23

Publicidad

loading