Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENTS
ADJUSTING THE TOP BURNER PRIMARY AIR (6.5 KW)
To carry out this operation, proceed as follows.
Close the gas supply tap.
1)
Pull off the knobs (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Loosen the screw (D).
4)
Set the burner mount (E) at a distance of 20
5)
mm and fasten the screw (D).
After completing the operation, fi t the con-
6)
trol panel (C) and the knob (A) back in place.
To carry out this operation, proceed as follows.
Close the gas supply tap.
1)
Pull off the knobs (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screws (D) and extract the cap (E).
4)
Pull off the cone (F).
5)
Clean the cone (F) and its seat.
6)
Coat the cone with grease (F), fi t it in its seat
7)
and turn it a few times.
Pull off the cone (F) to remove the excess
8)
grease.
Fit the cone (F) and the cap (E) back in place.
9)
After completing the operation, fi t the con-
10)
trol panel (B) and the knobs (A) back in place.
NOTE: We recommend gas STABURA-
GAS N32 by KLÜBER LUBRICATION ITALIA
S.A.S.
3386390_inst_GB_rev.1
A C
GREASING THE GAS TAP
A C
ENGLISH
E
B
E
F
D
B
D
15
Publicidad
