Replacement Of The Gas Valve Minimum Nozzle (Oven); Replacing The Oven Burner Nozzle; Replacing The Top Burner Pilot Light Nozzle - Angelo Po 1S1FA0GV Manual De Uso

PART REPLACEMENT

REPLACEMENT OF THE GAS VALVE MINIMUM NOZZLE (OVEN)

To carry out this operation, proceed as follows.
Close the gas supply tap.
1)
Pull off the knobs (A).
2)
Undo the screws (B) and remove the control
3)
panel (C).
Remove the injector (D) and replace it with
4)
the one suitable for the type of gas in use (see
table at the end of the manual).
Fully screw the injector
5)
After making the replacement, seal the screw
6)
with paint.
After completing the operation, fi t the control
7)
panel (C) and the knobs (A) back in place.
To carry out this operation, proceed as follows.
Close the gas supply tap.
1)
Undo the screws (B) and remove the control
2)
panel (A).
Unscrew the nozzle (C) and replace it with
3)
the one suitable for the type of gas in use (see
table at the end of the manual).
After completing the operation, fi t the control
4)
panel (A) back in place.

REPLACING THE TOP BURNER PILOT LIGHT NOZZLE

To carry out this operation, proceed as follows.
Close the gas supply tap.
1)
Pull off the knobs (A).
2)
Undo the screws (B) and remove the control
3)
panel (C).
Unscrew the union (D).
4)
Remove the nozzle (E) and replace it with the
5)
one suitable for the gas type being used (see
table at the end of the manual).
Tighten the union (D) again.
6)
After completing the operation, fi t the control
7)
panel (C) and the knobs (A) back in place.
3386390_inst_GB_rev.1

REPLACING THE OVEN BURNER NOZZLE

A
C
C
B
A
B
A C
B
ENGLISH
D
E
C
D E
10
17