Descargar Imprimir esta página

IBM TS4300 Guia Del Usuario página 276

Publicidad

• Tape spooled off the supply reel - All the tape appears to be on the take up reel and no tape is on
the supply reel (inside the cartridge). Test the drive after the procedure is completed.
• Tape pulled from leader pin (or broken at the front end) - All the tape appears to be on the supply
reel (inside the cartridge) and little or no tape appears to be on the take up reel. The leader block is
positioned in the take up reel. Return the drive after the procedure is completed.
• Tape broken in mid-tape - Tape appears to be on both the supply reel (inside the cartridge) and take
up reel. Test the drive after the procedure is completed.
• Tape tangled along tape path - Tape appears to be tangled and damaged but intact. Return the
drive after the procedure is completed.
-- OR --
• No damage to tape (or no apparent failure) - There appears to be no damage or slack to the tape.
Return the drive after the procedure is completed.
Full height drive: Tape spooled off supply reel
About this task
Note: If the cartridge in the drive is an INPUT tape that contains ACTIVE or 'ONLY COPY' data (there is no
backup), eject commands that are issued at the host fail to unload the tape, and power-cycling the drive
fails to eject the cartridge, make no further attempts to unload this tape. Call Technical Support and open
a PMR if one is not already open, to initiate the process of sending the drive with the loaded cartridge in
for recovery.
Procedure
1. With the front of the drive facing you, pull an arm's length of tape out of the take up reel from the left
side of the drive.
2. From the take up reel, thread tape around the rear of the tape path and over the head and rollers on
the left side of the drive.
3. Set the drive on its left side with the head and tape path facing up.
4. Moisten a cotton swab with water and wet approximately 13 mm (0.5 in.) of the tape end and feed it
onto the supply reel (inside the cartridge).
5. From the bottom of the drive, insert a 2.5 mm offset hex wrench through the bottom cover access hole
and into the reel motor axle.
244  IBM TS4300 Tape Library Tipo de máquina 3555: Guía del usuario
IBM Confidential

Publicidad

loading

Este manual también es adecuado para:

3555