Publicidad
Idiomas disponibles
Idiomas disponibles
ENGINE OIL DILUTION
During normal engine operation, the engine electronic control unit (ECU) software is able
to estimate the engine oil wear status through an internal algorithm.
GB
Upon each oil change interval, it is necessary to reset the "Oil Dilution Calculation"
function.
IMPORTANT
This operation is mandatory and can be
carried out as follows:
A) With the diagnosis tool available
at centres authorised by VM MOTORI
STELLANTIS EUROPE.
B) Through the following operating
sequence:
1 - Turn the ignition key to "ON" with
the engine off.
2 - Fully press the accelerator pedal to
the end stroke.
3 - Hold the accelerator pedal pressed
for 3 seconds, then fully release it.
4 - Wait for another 3 seconds before
fully pressing the accelerator pedal
again.
5 - The sequence 2,3,4 must be
repeated for 5 times.
English
IMPORTANT
A correct operating sequence B is only
ensured in the following conditions:
- The engine application must
be equipped with potentiometer /
accelerator pedal supplied by VM
MOTORI STELLANTIS EUROPE and
directly connected to the ECU (Engine
Control Unit).
If necessary or in case of doubts,
contact the manufacturer of the vehicle
in which the engine is installed or a
workshop authorised by VM MOTORI
STELLANTIS EUROPE.
50
R754ISE5
42432106F
Publicidad
