Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
REVERSING DOOR SWING
1. Remove top cover from the door - Use a putty knife to
lift the inside edge of the top door cover out and up to
disengage from the door panel. Repeat on bottom cover.
2. Release door from top hinge - Remove two allen screws
from the top of the door and lift door panel off of two
bottom allen screws.
NOTE: There are nylon washers for each bottom allen
screw and one plastic bushing for the outside screw, do not
misplace these parts they help the door swing smoothly.
3. Remove plastic covers from top and bottom hinges and
remove screws securing the hinges. Reinstall screws in
holes after hinges are removed.
4. Remove existing screws from cabinet to reinstall hinges
on opposite side.
5. Install top and bottom hinges in new location.
6. Install the bottom allen screws, nylon washers, and
plastic screw cover (to the outside screw).
7. Before installing the door, there is another plastic
bushing for the top outside allen screw, remove from top
of the door and reinstall on opposite side.
8. Place door on the two bottom screws.
9. Secure top of door with allen screws removed in step 2.
10. Reinstall top and bottom covers on door. Insert front
pins first then snap into place.
11. Reverse door handle - Loosen 3 screws from inside door
panel until the handle disengages. Flip door handle
180 degrees and tighten screws.
16
Part Number 0000017452 Rev 00 06/22
Section 2
Publicidad
