Sleepnet MiniMe 2 Manual Del Usuario página 6

Cleaning is recommended on a daily basis. Hand wash the mask and components in warm water using a mild
detergent. Rinse the mask thoroughly after washing. Visually verify that the vent holes are clear and allow the
mask to air dry. Washing child's face prior to fitting the mask will remove excess facial oils and help extend the
life of the mask.
NOTE: Inspect mask prior to each use. Replace the mask if parts are damaged or gel is exposed due to tear
or punctures.
NOTE: The gel cushion, although silky to touch, will not tear, leak or detach from the mask under normal
use and following recommended cleaning and maintenance protocols. However, the gel cushion is not
indestructible. It will tear, cut and rip if subjected to mishandling or abuse. Do not clean in a dishwashing
machine. The warranty does not cover these types of product failures. Therefore, please handle your new mask
with care.
Resistance to air flow at 50 L/min: 0.90 cmH
Resistance to air flow at 100 L/min: 3.60 cmH
Dead space (approx): XS size- 20 ml
A-weighted Sound Pressure Level at 1 m distance: 29.89 dBA; A-weighted Sound Power Level: 32.93 dBA
Operating Temperature: Do not expose the mask to temperatures above 122˚F ( 50C˚)
1. Attach the tubing assembly to the MiniMe 2 Mask (Figure 1).
2. . Lay headgear flat with light gray side facing up with the head strap at the top as shown in Figure 2. Place
mask gel side down in the center of the headgear and thread all 4 straps through the slots as shown (Figure 2).
3. To place mask on child, detach one or both lower straps from the mask. Slip the headgear over the head.
Seat the bottom cushion of the mask between the upper lip and nose, and tip the mask up to contact the nose
(Figure 3).
NOTE: The Touchless Spacebar™ should not contact the forehead.
4. . Find the detached hook and loop fastener strap and reattach (Figure 4
5. . Ensure the headgear straps are parallel and the headgear is fully extended and flat across the back of the hea
6. Adjust the bottom headgear straps by using the hook and loop fastener tabs (Figure 5).
7. Adjust the upper headgear straps by using the hook and loop fastener tabs: detach the hook and loop fastener
tabs then pull straps forward to center the mask over face. Ensure headgear is centered by aligning the two
straps. Then pull straps back, adjust strap tension, and affix tabs (Figure 6).
8. Adjust the head strap by using the hook and loop fastener tab (Figure 7).
9. . If mask is uncomfortable repeat steps 6-
NOTE: Do NOT overtighten the headgear.
NOTE: The Touchless Spacebar™ should NOT touch the forehead. It should be parallel to the forehead
(Figure 8).
NOTE: For optimal seal and comfort, mask should be snug, but not tight. Adjust the tension by detaching the
straps, tightening or loosening the straps, and reattaching the hook and loop fastener tabs.
10. 0 Connect the mask tubing assembly to the positive airway pressure device tubing and turn the device on to
the prescribed pressure (Figure 9).
11. . Gently press the edges of the mask to change mask shape, create a comfortable fit, and reduce leaks.
NOTE: The MiniMe 2 Nasal Mask contains Custom Fit Technology™. This soft mask shell can be shaped
to follow the contours of a child's face. The Memory Wire™ embedded into the shell locks the customized fi t
in place.
12. Turn head from side to side while lying on the bed and identify areas of leak that may prevent sleep.
13. 3 If leaks are noticed at the bridge of the nose, slightly tighten the top straps as described in in step 7. The
Touchless Spacebar™ should not contact the forehead.
14. 4. If leaks are noticed at the upper lip or below the nose, slightly tighten the bottom stra
®
MiniMe 2 is a trademark of Sleepnet Corporation.
Visit our website at www.sleepnetmasks.com.
CONTENIDO: Máscara nasal pediátrica de ventilación MiniMe
6
CLEANING AND MAINTENANCE - SINGLE PATIENT USE
TECHNICAL INFORMATION
2
S size- 25 ml
USER INTRUCTIONS FOR THE MINIME
Máscara nasal de ventilación MiniMe
PRODUCTO NO SE FABRICA CON LÁTEX DE CAUCHO.
SÓLO RX
O
O
2
HECHO EN EE.UU.
M size- 37 ml
®
2 NASAL MASK
2
®
®
2 tubos y cascoeste
L size- 40 ml
ESPAÑOL
!