Factory Settings; Recall From Low Consumption; Operation: Vacuum Using Bags / Vacuum Using Containers; Creating Vacuum In Vacuum Bags - Orved evox 25 Manual De Uso

7.2 FACTORY SETTINGS
EVOX 25 / EVOX 25 H is provided with the following factory settings:
In case the Vacuum and Seal parameters are not modified, the machine will work as per the above mentioned values.
To change vacuum level or sealing time, proceed as per § 7.1.
7.3 RECALL FROM LOW CONSUMPTION
Press any key. The vacuum packing machine turns from the low consumption (intermittent LED flash) to the Stand-by
status (ready to be used).
7.4 OPERATION: VACUUM USING BAGS / VACUUM USING CONTAINERS
7.4.1 CREATING VACUUM IN VACUUM BAGS
1) Plug into a suitable electrical socket.
2) In case of first use, run the vacuum sensor calibration as described at § 6.1.
3) Once the pack has been prepared inside the vacuum chamber as described in the "PREPARATION" (cap.6), press START
key and close the lid exerting a slight pressure on the front.
4) Once the vacuum cycle ended, and the vacuum chamber has been decompressed, it's possible to open the lid and
take the sealed bag out. Verify the sealing quality and the lack of air bubbles inside the bag.
After the cycle ending an acoustic signal advice that the machine is ready for a new vacuum cycle.
Pressing SEAL key, during the vacuum cycle, the machine switches immediately to the sealing.
The vacuum cycle can be interrupted before the end, pressing STOP key. The machine interrupts the cycle
and the vacuum chamber is decompressed.
Rev. 02 - 05/2016 - Cod. 1500015 - Instruction manual for vacuum chamber packaging machines EVOX 25 / EVOX 25 H
VACUUM: storage vacuum cycle
(led 1 ON).
SEALING: sealing time suitable for storage vacu-
um bags, 90 micron thickness
(led + ON).
1 2
OPERATION
27