Creating Vacuum In Vacuum Containers (Container Inside The Vacuum Chamber) - Orved evox 25 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

OPERATION
7.4.2 CREATING VACUUM IN VACUUM CONTAINERS (CONTAINER INSIDE THE VACUUM CHAMBER)
1) Plug into a suitable electrical socket.
2) In case of first use, run the vacuum sensor calibration as described at § 6.1.
3) Put the container inside the vacuum chamber as described in the "PREPARATION".
4) Press PUMP key.
5) Start the vacuum cycle by pressing the START key and close the lid exerting a slight pressure on the front.
6) Once the required vacuum level (detectable through the vacuum gauge) has been reached press STOP key
7) Take the container out from the vacuum chamber and
close the valve on the lid, in order to avoid any air return
on the container.
Verify the cover seal.
After the cycle ending an acoustic signal advice that the
machine is ready for a new vacuum cycle.
28
Rev. 02 - 05/2016 - Cod. 1500015 - Instruction manual for vacuum chamber packaging machines EVOX 25 / EVOX 25 H
2
1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Evox 25 h

Tabla de contenido