Oil Tank Cleaning; Replacement Of Vacuum Chamber Gasket - Orved evox 25 Manual De Uso

MAINTENANCE
11.6 OIL TANK CLEANING
1) To reach the pump for maintenance, follow the procedure described at points from 3 to 6 in chap. 11.3
2) Drain the pump oil as described in chap § 11.3.
3) Use a setscrew wrench to undo the two screw fasteners on the block. Lift the intake block (Fig. 4).
4) Clean carefully all the oil tank, using a cloth soaked in the same kind of oil used for pump (Fig. 5).
5) Clean the gasket slot carefully and replace the gasket same, in case you find it worn or damaged.
6) Re-install the oil tank.
7) Refill the pump with oil up to the correct level and close the machine body.
11.7 REPLACEMENT OF VACUUM CHAMBER GASKET
In case of lack of vacuum/ insufficient vacuum, check the gasket. In case it was worn, it should be replaced.
The gasket needs to be cut using a Cutter.
1) Open the lid.
2) Remove the gasket on the vacuum chamber and clean the gasket slot
carefully (Fig. 6).
3) Insert the new gasket into its place pressing it deeply. Cut the correct size
with a cutter (Fig. 7).
4) Operate a vacuum cycle, in order to adjust the gasket.
Rev. 02 - 05/2016 - Cod. 1500015 - Instruction manual for vacuum chamber packaging machines EVOX 25 / EVOX 25 H
Fig. 4
Fig. 7
Fig. 5
Fig. 6
47