Orved evox 25 Manual De Uso página 40

INSTALLATION
5) Check the pump oil level.
• Fill the oil in the machines supplied without oil (the warning label is found on the packaging).
• In machines with pre-filled oil, check the correct level through the opening on the rear or lateral side, as shown.
• The ideal level corresponds with the centerline of the inspection window.
WARNING!
• Never start the machine if there is no oil in the pump!
• Do not remove, damage or change the plates applied to the machine.
6) Electric connection.
• Before installing the machine, make sure that any pre-existing electric plants are in compliance with the Law and
suitable for the plate data of the machine to be installed (V, kW, Hz, and power available).
• The machines are supplied with a power supply cable measuring 200 cm with standard Schuko 16A plug. The socket
must have a 10A fuse and must be easily accessible.
ELECTRICAL hAZARD!
• Verify that the power cable wasn't damaged or restrained.
• Put and remove the plug applying the traction on the plug same, and never
on the cable.
WARNING!
• Make sure that the plug is accessible even after the unit has been installed!
• If the machine plug is not easily accessible, the power supply network must be equipped with devices
for the omnipolar disconnection with an opening distance of the contacts that allows complete discon-
nection in overvoltage category III conditions.
• If the entire length of the cable is not used, DO NOT roll it up but leave it free and make sure that it does not
obstruct or endanger the passage of persons. Also make sure that it is not crushed or bent.
• Make sure that the power supply cable does not come into contact with any types of liquid, sharp or hot objects
and corrosive substances.
• Do not allow children or animals to play with the power supply cable.
40
Rev. 02 - 05/2016 - Cod. 1500015 - Instruction manual for vacuum chamber packaging machines EVOX 25 / EVOX 25 H