Working Environments - Corghi ProLine Truck 150 Manual De Uso

Working environments

The machine has two separate memories
a l l o w i n g t w o o p e r a t o r s t o w o r k
simultaneously with different settings.
This feature can make operations at the
workshop quicker because when, for
example, an operator is busy with removing
or remounting a tyre, the other operator
can use the machine to perform balancing
operations and vice versa.
In this manual, the two operators are
defined as operator 1 and operator 2.
When operator 1 has completed his tasks
on the machine or is involved in other
activities, operator 2 can work with the
machine using the settings for the wheel
type he is working on without altering the
settings entered by operator 1.
When the machine is switched on, the two
memories are set with the same values
by default.
To use this function, operator 2 must
proceed as follows:
1. When the machine is free, press [F+P6]
+
2. The LED next to the key will light up
telling you that operator 2 is active. The
message shown in figure 30 will appear
on the screen for one second.
Fig. 30: Enabling operator 2 memory
Operator 1 memory is kept
2. Perform all desired settings for wheel
dimensions, Program Type, Wheel Type
and unit of measurement. The settings
of operator 1 are stored in memory;
3. Perform balancing of the wheel or wheels;
4. When operator 2 has finished his/her
110
to select operator
tasks on the machine, operator 1 presses
[F+P6] +
settings used by the latter. The LED next
to the key will switch off telling you that
operator 1 is active. The message shown
in figure 31 will appear on the screen for
one second.
Fig. 31: Disabling operator 2 memory
Operator 1 memory will be retrieved
5. When operator 1 has completed his/her
tasks on the machine, the operator 2 can
press [F+P6] keys
again to restore the wheel settings
entered in step 2;
6. Tasks can continue, alternating the two
operators.
An operator can change the following
settings without editing the settings
entered by other operators:
• Wheel dimensions (distance, width,
diameter);
• Type of program (DYN, ALU 1P-ALU 2P,
ALU 1-ALU 2-ALU 3-ALU 4-ALU 5);
• Wheel Type (CAR, TRUCK, SUV);
• Unit of weight (grams or ounces);
• Unit of measurement of the wheel
dimensions (millimetres or inches);
• Type of balancing weights material (Fe/
Zn or Pb).
NOTE: the settings for the wheel's units
of weight and dimensions entered by
operator 2 are not stored in the machine's
permanent memory and therefore will
remain active only until the machine is
switched off.
User manual ProLine Truck 150
to restore all
+