Pneumatic Connection - Corghi ProLine Truck 150 Manual De Uso

- Electrical wiring must be sized according to:
• the electrical power absorbed by the machine, as specified on the machine data plate;
• the distance between the operating machine and the power supply connection point,
to ensure that the voltage drop under full load does not exceed 4% (10% during start-
up) of the rated voltage value specified on the plate.
- User must:
• fit a power plug in compliance with current regulations on the power supply lead;
• connect the machine to its own electrical connection fitted with a suitable 30-mA
current sensitive circuit breaker;
• install protection fuses on the power line that are suitably sized in accordance with
the indications given in the general wiring diagram contained in this manual;
• ensure that the workshop electrical system includes an efficient earth circuit.
- To avoid the machine being used by unauthorised personnel, it is recommended to
disconnect the power supply plug when the machine is not used (switched off) for long
periods.
- If the equipment is hard-wired to the main electrical panel (without using a plug), provide
for a key switch or a padlockable switch to restrict use of the equipment to authorised
personnel only.
WARNING
A good earth connection is essential for correct operation of the machine. NEVER
connect the machine ground wire to the gas pipe, water pipe, telephone cable or
other unsuitable objects.

PNEUMATIC CONNECTION

WARNING
All pneumatic connection operations must be carried out by qualified personnel only.
-The connection to the workshop pneumatic system must ensure a minimum pressure
of 8 bar (115 psi).
- A universal union is used for connection to the pneumatic system. No special or additional
adaptor is needed for connection.
User manual ProLine Truck 150
UK
81