Corghi ProLine Truck 150 Manual De Uso página 122

• dPy Display test.
• tAS Keypad test.
• uFc Voltage – frequency converter test.
• SMo Shaft smoothness test.
• LAS Laser device operation test (if
present).
• rEt Returns to SERVICE mode.
To scroll through the different menu
options, press [P4]
until the desired option is
displayed, then press [F+P9]
to confirm.
NOTE: The test programs listed are
mainly reserved for technical support
personnel but may also be run by end
users as they do not impair the machine
operation.
EnC Encoder disc test
This test allows you to control the function
of the encoder disc which informs the
machine of the angular position of the
shaft. A number indicating the angular
position will appear on the right display;
this number must be included between
0 and 255.
• To exit the test program, press [F+P9]
+
rPM Number of shaft rpm test
This test allows you to control the number
of shaft RPMs during the spin. A number
indicating the speed of the shaft will be
displayed on the right display.
122
or [P5]
+
.
By pressing [P8] Start
lowering the wheel guard, the machine
will run a spin cycle and at the end of
this will display the number of shaft
revolutions per minute.
To exit the test program, press [F+P9]
+
SiG pick-up data signal test
This program allows you to check the
pick-up signal. To run the test, you will
need to mount a balanced wheel with a
steel rim, 15" in diameter and 6" in width
(or as similar as possible) on the machine.
A 50-gram weight must be applied on the
external side of the wheel.
By pressing [P8] Start
lowering the wheel guard, the machine
will run a spin cycle in continuous mode.
To complete the test, press [P10] Stop
or raise the wheel guard.
To exit the test program, press [F+P9]
+
dPy Display test
The display test program will light up all
the LEDs and the 7-segment displays
in sequence so that faulty LEDs can be
identify. To turn on all LEDs and display
segments in sequence,
o [P5]
To exit the test program, press [F+P9]
User manual ProLine Truck 150
or by
.
or by
.
press [P4]
.