Corghi ProLine Truck 150 Manual De Uso página 95

MANUAL MEASUREMENT OF DIAMETERS d-1 AND d-2
With this method, a manual measurement of diameters d-1 and d-2 or of just the external
diameter d-2 (depending on the active Program Type) with the aid of a measuring tape. The
values to be entered are shown in table T3a.
Table T3a: Measurement of diameters d-1 and d-2 to manually enter data
Program
Type
ALU 2P Enter the nominal rim diameter.
Enter the actual diameter d-1
measured with the aid of a measur-
ALU 1P ing tape. The measurement must be
performed on the balancing plane
chosen for d-1.
ENTERING d-1 AND d-2 STARTING FROM THE DIAMETER NOMINAL
According to this second method, the nominal wheel diameter is used with the corrections
indicated in table T3b.
Table T3b: Determining diameters d-1 and d-2 starting from the nominal rim diameter
Program
Type
d-1 = nominal rim diameter.
ALU 2P
d-1 = nominal diameter – 1.0
ALU 1P
inches (or 25 mm.).
Since manual measuring is not required, this method is faster but the results may be slightly
less accurate.
Automatic acquisition of wheel dimensions for the DYN program
and Program Types (ALU 1-2-3-4-5)
To automatically introduce the wheel size data, proceed as follows:
1. Fit the wheel on the shaft.
2. Extract the Distance/Diameter sensor and place it on the rim as shown in figure 17.
3. Wait to hear the long acquisition beep and then set the Distance/Diameter sensor back
to the rest position;
User manual ProLine Truck 150
Internal diameter d-1
VALUE
Internal diameter d-1
External diameter d-2
Enter the actual diameter d-2
measured with the aid of a measur-
ing tape. The measurement must be
performed on the balancing plane
chosen for d-2.
Enter the actual diameter d-2
measured with the aid of a measur-
ing tape. The measurement must be
performed on the balancing plane
chosen for d-2.
External diameter d-2
d-2 = nominal diameter – 2.0
inches (or 50 mm.).
d-2 = nominal diameter – 2.0
inches (or 50 mm.).
UK
95