Corghi ProLine Truck 150 Manual De Uso página 116

7. Press the [P8] Start key
machine will carry out a spin. At the
end the words CAL 1 will appear on
the screen.
8. Mount the wheel on the shaft and enter
the wheel dimensions by pressing the
[P1] , [P2]
and [P4]
keys
not possible to enter the data with the
automatic acquisition system;
9. Press Start key [P8]
machine will run a second spin;
10. At the end of the spin, manually
rotate the wheel until the left display
shows the value 50. On the inner side
of the wheel, at 12 o'clock, apply the
50 g weight.
11. Press Start key [P8]
machine will run a third spin;
12. At the end of the spin, manually rotate
the wheel until the right display shows
the value 50. Remove the weight of 50
grams from the internal side and apply
it on the external side of the wheel at
12 o'clock.
13. Press Start key [P8]
machine will run a fourth spin;
14. Calibration is finished: the machine
automatically exits the calibration
program and returns to NORMAL
mode, ready to perform balancing.
116
. The
, [P3]
or [P5]
to edit the value. It is
: the
: the
: the
If you have anomalies during the
calibration procedure, the machine will
display the error message (for example
ERR 025). See section "Error codes"
and act accordingly to eliminate the
problem and continue/repeat/cancel the
calibration in progress.
Spins stopped using the [P10] Stop key
can be repeated by pressing
the [P8] Start key
How to exit machine calibration for
the CAR/SUV Wheel Type
At any time it is always possible to exit
the calibration procedure in progress
by pressing [F+P3]
. The machine will return to SERVICE
mode displaying SEr SEr. To return to
NORMAL mode, press [F+P3]
+ again. The calibration
procedure in progress will be cancelled
and the machine will use the previous
calibration values.
User manual ProLine Truck 150
.
+