MedComp HEMO-CATH Instrucciones De Uso página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12
Before dialysis begins all connections to catheter and
extracorporeal circuits should be examined carefully.
Frequent visual inspection should be conducted to detect leaks
to prevent blood loss or air embolism.
If a leak is found, the catheter should be clamped immediately.
Caution: Only clamp catheter with in-line clamps provided.
Necessary remedial action must be taken prior to the
continuation of the dialysis treatment.
Note: Excessive blood loss may lead to patient shock.
Hemodialysis should be performed under physician's
instructions.
If the catheter is not to be used immediately for treatment,
follow the suggested catheter patency guidelines.
To maintain patency between treatments, a heparin lock must
be created in each lumen of the catheter.
Follow hospital protocol for heparin concentration.
1. Draw heparin into two syringes, corresponding to the amount
designated on the arterial and venous extensions. Assure that
the syringes are free of air.
2. Remove injection caps from the extensions.
3.
Attach a syringe containing heparin solution to the female luer
of each extension.
4. Open extension clamps.
5. Aspirate to insure that no air will be forced into the patient.
6. Inject heparin into each lumen using quick bolus technique.
Note: Each lumen should be completely filled with heparin to
ensure effectiveness.
7. Close extension clamps.
Caution: Extension clamps should only be open for aspiration,
flushing, and dialysis treatment.
8.
Remove syringes.
9.
Attach a sterile injection cap onto the female luers of the
extensions.
In most instances, no further heparin is necessary for 48-72
hours, provided the lumens have not been aspirated or flushed.
Warning: DO NOT use iodine or iodine based products on this
catheter. Failure of catheter will occur. Alcohol based solutions are
recommended as the antiseptic solution that can be used on this
catheter.
• Clean the skin around catheter. Cover the exit site with
occlusive dressing. Leave the extensions, clamps, adapters
and caps exposed for access by staff.
Wound dressings must be kept dry. Patients must not swim,
shower, or soak dressing while bathing. If adhesion of dressing
is compromised by profuse perspiration or accidental wetting,
the dressing must be changed by the medical or nursing staff
under sterile conditions.
HEPARINIZATION
SITE CARE
-6-

Publicidad

Tabla de contenido
loading

Tabla de contenido