Dropping The Feed Dogs; Darning - Sears Kenmore 385.17822 Manual De Instrucciones

e Dropping the Feed Dogs
The drop feed lever is located underneath the free arm bed on the back
side of the machine.
O To raise the feed dogs, push the (_) To drop the teed dogs, push the
]everinthedirectionofthearrow, lever in the direction o! the
as illustrated, arrow, as illustrated.
Then turn the handwheel.
" Feed dogs must always be up tor normal sewing.
t
1
I
Top thread
|ensJon
control 2 to 6
Set the Machine
Stitch width control 0
WDTH
!
©
Slitch length
conlrol any number
(nol necessary Io
adiust)
LENGIH
F: Sa_i_ a_=i_ch toot
Drop teed lever
Darning
1. Drop the feed dogs.
2. Place the fabric, with the hole in the center,
on an between embroidery hoop, as shown.
3. Lower the presser bar and sew at a slow speed.
4. Move the fabric back and lorth slowly until you
have covered the darning area.
5. Turn the/abric 1/4 turn and sew another layer of
stitching over the first layer.
NOTE: If your fabric is thin or badly damaged
use a separate piece of fabric under the
hole to reinlorce it.
6. When you finish darning, return the pressure
adjusting lever to 3.
62