Kichler Kimberley Manual De Instrucciones página 13

MAKE THE ELECTRIC CONNECTIONS
WARNING: To avoid possible electrical shock, be sure you have turned off the
power at the main circuit panel.
Follow the steps below to connect the fan to your household wiring. Use
the wire connecting nuts suppled with your fan. Secure the connectors with
electrical tape. Make sure there are no loose wire strands or connections.
NOTE: The CoolTouch™ Control System is equipped with 16 possible
frequency combinations to prevent interference from or with other remote
control units. The frequency switches on your receiver and transmitter have
been preset at the factory. Please recheck to make sure the switches on
transmitter and receiver are set to the same position, any combination of
settings will operate the fan as long as the transmitter and receiver are set to
the same position. (Fig. 14)
Step 1. Insert the receiver in the ceiling mounting bracket with the flat side of
the receiver facing the ceiling. (Fig. 15) For best performance, make sure the
Black Antenna, on the end of the receiver, remains extended and not tangled
with any of the electrical wires.
Code switch
Fig. 14
Receiver
Fig. 15
Hanger
bracket
13
Kimberley |
™