Safety Rules - Kichler Kimberley Manual De Instrucciones

SAFETY RULES

1. To reduce the risk of electric shock, insure electricity has been turned off at
the circuit breaker or fuse box before beginning.
2. All wiring must be in accordance with the National Electrical Code and local
electrical codes. Electrical installation should be performed by a qualified
licensed electrician.
3. WARNING: To reduce the risk of fire, electric shock, or personal injury, use
mounting screws provided with the outlet box. Most outlet boxes
commonly used for the support of light fixtures are not acceptable for fan
support and may need to be replaced. Due to the complexity of the
installation of this fan, a qualified licensed electrician is strongly
recommended.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
OR PERSONAL INJURY, MOUNT FAN TO OUTLET BOX
MARKED "ACCEPTABLE FOR FAN SUPPORT".
4. The outlet box and support structure must be securely mounted and
capable of reliably supporting a minimum of 50 pounds. Use only CUL
Listed outlet boxes marked "FOR FAN SUPPORT".
5. The fan must be mounted with a minimum of 7 feet clearance from the
trailing edge of the blades to the floor.
6. To operate the reverse function on this fan, press the reverse button
while the fan is running.
7. Avoid placing objects in the path of the blades.
8. To avoid personal injury or damage to the fan and other items, be
cautious when working around or cleaning the fan.
9. Do not use water or detergents when cleaning the fan or fan blades.
A dry dust cloth or lightly dampened cloth will be suitable for most
cleaning.
4 | KICHLER.COM
WARNING
10. After making the electrical connections, spliced conductors should be turned
upward and pushed carefully up into outlet box. The wires should be spread
apart with the ground wire and white (common) wire to one side with the
black (load) wire to the other side of the outlet box.
11. Electrical diagrams are reference only. Light kits that are not packed with
the fan must be CUL Listed and marked suitable for use with the model fan
you are installing. Switches must be CUL General Use Switches. Refer to the
Instructions packaged with the light kits and switches for proper assembly.
packed with the fan must be Listed and marked suitable for use with the
model fan you are installing. Switches must be General Use Switches. Refer
to the Instructions packaged with the light kits and switches for proper
assembly.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE
BLADE BRACKETS (ALSO REFERRED TO AS FLANGES) DURING
ASSEMBLY OR AFTER INSTALLATION. DO NOT INSERT OBJECTS
IN THE PATH OF THE BLADES.
SPECIAL NOTICE
This appliance is equipped with a "Wattage Limiting Device" required
by the United States Department of Energy. The device has been
installed at the factory and can not be removed.
Installing Lamps in excess of 75 total watts will disable the unit's
light fixture. If this should happen, you will need to reset the
lighting fixture by turning the power off to the ceiling fan and/or
light fixture, reinstalling lamps totaling less that 75 watts and
then turning the power back on.