Kichler Kimberley Manual De Instrucciones página 9

HANGING THE FAN
Step 7. Loosen the two set screws and remove the hitch pin and retaining clip from
the coupling on top of the motor assembly. (Fig. 9)
Step 8. Carefully feed the electrical lead wires from the fan up through the
downrod. Thread the downrod into the coupling until the Hitch pin holes are
aligned.
Next, replace the hitch pin and retaining clip. Tighten both set screws. (Fig. 9)
Supply wires
Downrod
Set screws
Retaining Clip
Fig. 9
Set screws
Hitch pin
9
Kimberley |
™