Working With The Unit - Kulzer cara Print LEDcure Instrucciones De Uso

3. Time: Select between 1 – 30 minutes. Set the parameter using the 'up' (right) and 'down' (left) buttons.
Press the 'Enter' button (middle) to confirm. Editing is complete, the display jumps back to the program
start screen (w/ indication of the program parameters).
GB
-14-
NOTE
• The real item temperature is very much dependent on the absorption of the LED radiation by the material.
Therefore, the LED power and temperature setting must be configured individually in combination with
each customer-specific material.
• The operator is solely responsible for the customer-specific parameters and processes, as well as their
configuration. Always follow the specifications provided by the manufacturer of the material.
• Certain combinations of LED power and temperature are not realistic based on operational experience.
The following combinations to polymerise 3D printing resins can serve as a guide:
80°C / 176°F
70°C / 158°F
60°C / 140°F
50°C / 122°F
40°C / 104°F
30°C / 86°F
Temp. Off
Legend: The item temperature of combinations with a red 'X' will probably be exceeded. When the heating is
switched off (Temp. Off), a temperature is only set according to the absorption properties of the material or
item. The item temperature may deviate from the air temperature indicated.

8.4 Working with the unit

Switch on the unit at the front.
Open the sliding door and place the 3D-printed item on the rotating plate. Close the door.
Do not place or cure items in the unit that still contain residues or adhering material from flammable
solvents or cleaning fluids and are not completely dry.
NOTE
Make sure (if possible) that the item is not placed in the unit in the center of the rotating plate, but slightly
to the side. Exposure to the attached LEDs from underneath the rotating plate is supported by positioning the
item outside of the center of the rotating plate.
√ √ √
√ √ √
√ √ √
√ √ √
√ √ √
√ √ X
√ √ √
20% 30% 40%
√ √ √
√ √ √
√ √ √
√ X X
X X X
X X X
√ √ √
50% 60% 70%
LED Power in %
√ √ √
√ √ √
√ √ √
X X X
X X X
X X X
√ √ √
80% 90% 100%