Search For Cara Cure Guide Update; Cara Cure Guide Update - Kulzer cara Print LEDcure Instrucciones De Uso

The icon of the triggered error is indicated on the right side of the display. Possible errors include:
LED module temperature exceeded
LED light / power supply defect
Chamber temperature sensor defect
GB
Door open
-16-
Rotating plate blocked or motor defective
Pressing the 'Enter' button acknowledges the error message and the display jumps back to program selection. If
error conditions are still present when the program is initiated, starting it is not possible

8.6 Search for cara Cure Guide Update

The material parameters current at the time of manufacture have already been installed on the device. However,
it remains the operator's responsibility to search for cara Cure Guide updates regularly on the Kulzer homepage.
NOTE
The 'cara Cure Guide' is a important component of the operating instructions,they must always be kept up-to-date
and followed by all operators to avoid possible risks for material processing.
The cara Cure Guide version installed on the device is shown in the info display after switching the unit on
(see section 8.1).
If a newer version of the cara Cure Guide is available online, first download the file [.ZIP] on a local PC /
laptop / tablet. To unzip and install, see section 8.7.
NOTE
At the same time, the operating personnel must be informed immediately of the update and any parameter
changes, supplements, notes, etc. that may be associated with it.

8.7 cara Cure Guide Update

Updated Kulzer material programs in the cara Cure Guide (e.g. "cCG_V20-01.zip") are able for download via
the Kulzer homepage. The file name "V20-01" means "Version 2020 - Edition 01"
NOTE
When delivered, the device is provided with the material data current at the time of production and is ready
to use – subsequent update instructions only apply for future updates.
The device is equipped with a USB port at the rear. This is exclusively for use for material data transfer in
the cara Cure Guide from a PC / laptop / tablet. Devices connected to the USB port must meet the require-
ments of IEC 62368-1
new error message.