The actual temperature indicator with the preceding arrow signifies that the chamber temperature is > 5°C
above the target program temperature. The pause symbol in the bottom line indicates that initiating the
programs is not currently permitted.
NOTE
Do not place an item into the chamber when it is overheated. The item material may be damaged.
If the temperature drops to a value < 5°C above target temperature, the pause sign in the middle changes to
and the program can be initiated. If the chamber temperature drops below the target temperature, the target
temperature is indicated again.
If the wrong program was selected by mistake, press 'ESC' (left) to return to program selection. The selected
program is initiated by pressing 'Start' (middle).
GB
NOTE
-12-
If the program contains faulty parameters, it is not able to be initiated and only 'ERR' appears on the display.
If errors are still present, the program will also not be able to be initiated. An error (ERR) is indicated in the
bottom line instead of the start symbol and the symbol of the present error is displayed (e.g.: Door open).
Please see section 8.7 for possible causes and workarounds.
NOTE
There are no provisions for temporary changes to program parameters; if necessary, a new program must be created.
If all parameters are correct and the program was initiated using the middle button, the flashing 'Heating'
icon indicates the preheating phase. The display shows the current process temperature in the middle and
the target temperature on the right.
A program run can be cancelled within the first 15 seconds by pressing the middle 'Stop' button. After 15 seconds,
this option disappears and the program will be run through completely.
If the program does not have a temperature preselected (setting '- - °C'), the preheating phase is skipped.
In the next image, an animated hourglass shows the program run. If over 1 minute, the remaining runtime is
indicated in minutes:seconds; if under 1 minute, it is only indicated in seconds. The actual temperature is
located on the right side of the display (or alternatively '- - °C,' if no temperature is pre-set).