Installing Your Multijet Pro - alfatest Multijet Pro Manual Del Usuario

Resistance (Indicates that the value displayed in the last three digits is the resistance value of the
injector displayed);
Function selection;
Thousand (The number displayed should be multiplied by 10 to obtain the real value);
Operation realtive to the Ultrasound;
USB communication or test accessories connected and active;
COM

3.0 - INSTALLING YOUR MULTIJET PRO

ATTENTION
DO NOT PRESS ANY KEY OF THE PANEL UNTIL YOU HAVE LEARNED THE SEQUENCE BELOW.
- Install the Multijet PRO on a plane (level) surface, consistent, without vibrations and that provides good
STEP 1
ventilation.
It must be at most 1.2m from the power supply point where it will be connected.
– Use socket with three pins, good grounding and firm contacts. Check the voltage available in the socket
STEP 2
to be connected.
Correctly select the voltage on the equipment side and connect the power cable to the socket.
Turn on the Multujet PRO through the On/Off switch.
THE EQUIPMENT LEAVES THE PLANT SET AT 220V!
:
SOCKET WITH GROUND PIN
15
MULTIJET PRO