Executing Simultaneous Operations (Multitask) - alfatest Multijet Pro Manual Del Usuario

MULTIJET PRO

7.0 - EXECUTING SIMULTANEOUS OPERATIONS (MULTITASK)

One of the great novelties of the Multijet PRO is the execution of 3 simultaneous operations (Multitask) controlled
through the same panel (display and keys). It´s possible activate two internal functions and control a external
accessory.
Through it, the professional has quick and practical access to the Injector Test and Cleaning or Idle speed actuator
functions.
This gives the user freedom to perform procedures simultaneously. e.g.: Cleaning and Testing injectors. The user
thus has greater practicality and time savings in the workshop, increasing the yield in his day to day.
To perform simultaneous operations, press the "Function" key , repeat until the "F" icon come on . If there is one or
more active or paused tasks, there will be a sequential selection (clockwise) until comes the turn of the icon
function "F ".
During the test, the "F" icon will be off and it will come on on pressing the "Function" key.
Remember: The keyboard functions are according to the icon on.
The icon "F" on, indicates that the user can select a different function to be performed.
RULES:
-You can not run simultaneously two or more fuctions between 1 and 10. If any one of them is active the others do
not appear in the selection.
-If any of the functions between 11 and 16 are activated, the others do not appear in the selection.
If any function between 1 and 10 + any function between 11 and 16 + function 17 are actived, the display does not
show any option as the figure below.
IT IS NOT POSSIBLE TO CONDUCT THE IDLE SPEED ACTUATOR TEST WHEN THE INJECTORS ARE
BEING CLEANED (ULTRASOUND VAT) BECAUSE THE ACTUATOR CONNECTOR WILL BE UNDER
USE BY THE CLEANING PROCEDURE.
36