Controls And Instruments - Honda HF2317 Manual De Instrucciones

3.4 ASSEMBLING THE LEVERS FOR TIPPING THE GRASS
CATCHER
HF2•••HT•
Fit the lever shaft (1) in the groove
between the two plates (2) and fas-
ten them to the inner grass catcher
brackets (3) using the nuts and
screws supplied (4), as shown by
the sequence in the figure.
Connect the end of the rod (5) of the
lifting piston to the lever (6) with the
pin (7) and attach the two snap rings
(8).
Before attaching the grass catcher
to its supports, make sure that the
tipping lever moves properly.
3.5 REMOVAL OF THE GRASS CATCHER PAWL SPRING RE-
TAINER
For transport reasons the grass catcher
(1) pawl spring is fastened to the rear
plate by the retainer (2). This retainer
must be removed before the grass
catcher frames are fitted and must not
be used any longer.
3.6 FITTING THE FRONT BUMPER
Mount the front bumper (1) on the bottom of the frame (2) using the
four screws (3).
EN 8

4. CONTROLS AND INSTRUMENTS

4.7
4.2
B
4.1
4.3
A
4.9
4.4
B
4.12
A
4.1 STEERING WHEEL
Turns the front wheels.
4.2 CHOKE CONTROL
Used to turn on the engine when cold. It enriches the mix-
ture and must only be used for the necessary time.
4.3 THROTTLE LEVER
Adjusts the engine speed. The positions are indicated on the plate
showing the following symbols:
«SLOW» for minimum engine speed
«FAST» for maximum engine speed
– When moving from one area to another, put the lever in a position
between «SLOW» and «FAST».
– When cutting, shift into «FAST".
4.4 KEY IGNITION SWITCH
This key operated control has three positions:
«OFF»
«ON»
«START»
On being released at the «START» position, the key will automati-
cally return to «ON».
4.11.2
B
4.8
4.11.3
4.10.a
4.11.1
A
4.5
4.6
everything is switched off;
activates all parts;
Switch on the starter motor to ignite the
engine.
A
B