Imaging Head Holder (Hh1003) - Stryker SPY-PHI Manual Del Usuario

To attach to the rail:
1. Open the rail clamping knob until
the L-brackets fit over the rail,
then tighten to secure.
2. Insert the column of the Main Arm
into the column opening, adjust
the column to the desired angle,
and tighten the column clamping
knob when the main arm is in the
desired position.

8.3 Imaging Head Holder (HH1003)

Connects to the distal end of the main
arm to provide an attachment point for
the SPY-PHI imaging head.
To connect the imaging head holder to
the distal end of the main arm:
1. Insert the imaging head
hex shaft into the chuck
until it is fully seated.
2. Twist the collar clockwise to
lock the quick connect
accessory into place. Check
to see that the shaft is
secured, and the collar is in
the locked position.
To disassemble: Reverse the above steps.
To position the imaging head and lock in place:
3. Rest the neck of the draped
imaging head against the
thin rigid band of the holder
(as shown).
©2020 IFU-0100 / rev3 8