Operation - EFI / Egov
STOPPING THE ENGINE
1. Turn key to OFF position.
2. Turn fuel valve to OFF position (if equipped).
SAFE ANGLE OF OPERATION
MAXIMUM angle of operation cannot exceed 15° degrees slope.
HIGH ALTITUDE OPERATION
Carburetor Modifications (EFI engines are self adjusting)
The standard carburetor air-fuel mixture may be too rich when operated
at high altitude resulting in possible decreased performance and
increased fuel consumption. Please have an authorized Service Center
modify this engine's carburetor if it is operated continuously above 5000
feet. Failure to modify may result in poor engine performance, spark
plug fouling, hard starting, and increased emissions.
Carburetor modi cation by an authorized Service Center will improve
performance and allow this engine to continually meet US EPA and
California ARB emission standards throughout its useful life.
Important Note
When the carburetor has been modi ed for high altitude operation, the
air-fuel mixture may be too lean for operation at 5000 feet or below. This
could result in the engine overheating and could cause serious engine
damage. Please have an authorized Service Center restore high altitude
converted carburetors back to the original factory speci cation before
operating below 5000 feet.
To locate the nearest dealer, please visit our website:
www.lctusa.com
1
Keyed RUN/STOP Switch is located
on equipment control panel
2
On EFI equipped engines, turn
Keyed RUN/STOP Switch to OFF.
GEN II Snow Engine Manual 11