LCT 599542602 Manual Del Usuario página 8

Controls & Features (EFI / Egov)
CONTROLS
1. Key Switch
Keyed RUN / STOP switch is located on the equipment's control panel between the handle bars. Allows for quick and easy starts.
2. Fuel Control Knob (if equipped)
The Fuel Control Knob opens and closes the passage between the fuel tank and carburetor. The Fuel Control Knob must be in the
"ON" position for the engine to run. When the engine is not in use, be sure to turn the Fuel Control Knob to the "OFF" position.
3. Primer Bulb (not on EFI engines)
The Primer Bulb system is designed to enrichen the fuel mixture for starting a cold engine. DO NOT over prime the fuel system.
To properly use the Primer Bulb system, depress Primer Bulb 3 times maximum when starting a cold engine. Do not use Primer
Bulb system when attempting to start a warm engine.
4. Oversized Recoil Handle
The engine is started by pulling the Recoil Handle. Always grip
rmly and have your body positioned properly when pulling.
When starting the engine:
´ Slowly pull Recoil Handle until resistance is felt.
´ Then pull rmly the full length of the rope to start engine.
´ Never wrap thumb around Recoil Handle in the event of
engine kick-back.
5. Oversized Gas Cap
Allows for easy opening and closing for more ef cient refueling.
6. Electric Start
7. High Oil Fill Tube (not on EFI engines)
Allows convenient location for adding oil during the life
of the engine. Check oil level with lower oil ll plug (ref. 9)
per owner's manual instructions.
8. Oil Drain
The oil drain can be located on either side and
on some models extend out below the recoil housing.
9. Oil Dip Stick
This location is for checking oil level
(also used for adding oil on EFI engines).
10. Fuel Filter (EFI engines only)
Located behind the front panel of the engine.
1
Keyed RUN/STOP Switch is located
on equipment control panel
2
3
8
5
10
8
5
7
4
6
9
4
6
9
GEN II Snow Engine Manual 5