FIGURE 9 – INSERT FURNACE
25,000 - 35,000 BTU/hr. MODELS
FIGURE 10 – NAIL PLACEMENT
BOTTOM OF FURNACE
NAIL FURNACE LEG TO STUD
OR FLOOR PLATE
(SEE DETAIL BELOW)
REAR OUTLET KIT INSTALLATION (OPTIONAL)
If a Rear Outlet Register Accessory is used, the following procedure
must be completed before placing furnace body into wall recess.
Figure 11 Attach speed nuts to outer shield and remove knockout
plates from both the outer and inner shields as follows:
1.
Punch in the lower corners with a screwdriver blade.
2.
Break the knockout side and bottom connecting tabs
by holding a screwdriver blade sideways against the
tab and striking the head of the screwdriver lightly with
a hammer.
3.
Swing the plate outward; bend it back and forth to
break the top tabs. Use caution when handling sharp
metal edges.
CAUTION: Do not install rear outlet kit where grille may be
blocked by a door, curtains, or any other obstruction.
16
COZY TOP VENT GRAVITY GAS WALL HEATER
INSTALLING YOUR FURNACE
B/W VENT
BOTTOM OF
FURNACE
LEG
NAIL AT ANGLE
FLOOR PLATE
WARNING: Never shear or cut the furnace legs.
FIGURE 11 – REMOVE KNOCKOUT PLATES
INNER SHIELD
10 - 24 SPEED NUT
After furnace is in position, install rear outlet register as shown
in Figure 12. Have damper in open position when inserting the
assembly. Secure the rear outlet register to speed nuts with the
machine screws furnished.
FIGURE 12 – MOUNTING REAR OUTLET REGISTER
FURNACE SHIELDS
PLASTER GROUND
REAR REGISTER
OUTLET
KNOCKOUT PLATE
ON OUTER SHIELD
HOLD SCREWDRIVER
SIDEWAYS AGAINST
TABS AND STRIKE
LIGHTLY WITH
HAMMER