Lighting The Pilot - COZY C255H Manual Del Propietário

8. To find the pilot, follow metal tube from the gas control.
The pilot is mounted on the side of the burner. Figure 22
9. Turn knob on the gas control counterclockwise PILOT .
FIGURE 22 - PILOT AND GENERATOR
10. Push in the control knob all the way and hold in. Immediately
light the pilot. Continue to hold the control knob in for about one
(1) minute after the pilot is lit. Release the knob and the pilot
flame will pop back up. The pilot should remain lit. If it goes
out, repeat Steps 5 through 10.
If knob does not pop up when released, stop and
immediately call your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas
control knob OFF and call your service technician or
gas supplier.
11. Close pilot observation door, tighten wing nut (if equipped).
12. Turn gas control knob counterclockwise
to the ON position
13. Close control access panel.
14. Turn on all electric power to the appliance (if applicable).
15. Set thermostat to desired setting.

LIGHTING THE PILOT

1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be
performed (if applicable).
3. Remove control access panel.
4. Push in gas control knob slightly and turn
clockwise to OFF . Do not Force.
5. Replace control access panel.
IMPORTANT:
KEEP BURNER AND CONTROL COMPARTMENT CLEAN.
WARNING: Due to high surface temperatures, keep
children, clothing, furniture or any combustible material
away from the furnace.
OPERATING YOUR FURNACE
THE FURNACE OPERATES IN THE FOLLOWING SEQUENCE:
1. Thermostat turns on the main burner.
2. Heat builds up in the furnace and starts the fan (if equipped).
The heated air comes out the front panel louvers.
3. When the thermostat setting is reached, it shuts off the
main burner.
4. The fan runs until the heat is removed from the furnace,
then it turns off (if equipped).
Your furnace is equipped with a 100% safety pilot that will shut
off the gas supply in case the pilot is not burning or functioning
properly. Make sure the pilot is adjusted properly and that the
pilot generator connection at the control valve is tight. If the
furnace will not stay lit, call your local gas utility or a qualified
service person.
If furnace is equipped with a manual spark igniter, follow
these steps:
1. Review the pilot lighting instructions.
2. When instructed to Light the Pilot, depress the red button
located on the burner pan for pilot ignition. If necessary,
depress the red button vigorously several times for pilot ignition.
3. If pilot fails to ignite or a spark is not present while actuating
the red button or by using a match, repeat steps 5 through
10 listed in Lighting the Pilot.
WARNING: The surface of the furnace is hot during
operation. Keep children, clothing, furniture, and
flammable material away from it. Keep all access
doors and panels in place except for inspection and
maintenance. On new installations, the gas lines will
be filled with air and it may take several minutes to
establish the pilot flame.
WARNING: Danger of property damage, bodily injury
or death. If the furnace overheats or fails to shut off,
close manual shutoff gas valve to the furnace before
turning off electrical power to the accessory fan.
WARNING: Protect your eyes against the danger of
ignition flash and eye injury or blindness. Never attempt
to light the pilot with the gas control valve knob in the
ON position. Flashback could occur.
COZY TOP VENT GRAVITY GAS WALL HEATER
23