Basic Materials Needed; Basic Tools Needed; Optional Accessories; Helpful Installation Information - COZY C255H Manual Del Propietário

BASIC MATERIALS NEEDED

Pipe and fittings to make gas connections to the furnace.

Vertical venting materials. See page 15, Figure 8.

Pipe joint compound resistant to propane.

Electrical wiring supplies as needed. Minimum wire size is

#14 gauge copper.

BASIC TOOLS NEEDED

Hand drill or properly grounded electric drill

Expansion bit 1/2 to 1-5/8 or 1/2 and 1-1/2 blade bits

1/8 and 3/16 drill bit (metal)

6 ft. folding rule or tape measure

Screwdriver (medium blade)

Screwdriver (Phillips and Flat Head)

Pliers (wire cutting)

Hammer

Stud Locater or small finishing nails

Tin Snips

8" adjustable wrench

12" adjustable wrench

7/8" wrench

3/4" wrench

1" wrench

Gloves and safety glasses


HELPFUL INSTALLATION INFORMATION

The following booklets will help you in making the installation:
ANSI/NFPA 70, or current edition "National Electrical Code".
In Canada: CSA C22.1 Canadian Electrical Code.
American National Standard Z223.1 or current edition of the "National
Fuel Gas Code."
Obtain from the American National Standard Institute, Inc., 1430
Broadway, New York, NY 10018. In Canada, CAN/CGA B149.
6
COZY TOP VENT GRAVITY GAS WALL HEATER
INTRODUCTION

OPTIONAL ACCESSORIES

Blower Accessories 2901, 2907 - May be used on all models and
mounts on top of a furnace. This blower increases circulation of warm
air through the heated space. A 115V outlet adjacent to the furnace
is required.
Trim Strip Kit 4701 - Provides a finished edge for sides of the
wall furnace.
Free Standing Accessory 4901 - May be used with single&sided
models. This accessory allows the furnace to be mounted on the
surface of a wall.
Vent Adapter Kit 9902, 9910 - Optional vent adapter, typically used
when the furnace is vented into a properly lined chimney.
Rear Outlet Registers 6901, 6919, 6920 - May be used with
single&sided models when recessed into a standard 2x4 inch interior
stud partition. This accessory directs some of the heated air into the
room opposite the one in which the furnace is installed.
Oval B/W Vent Kit 9929 - This U.L. listed B/W vent kit contains four
feet of oval, double&walled vent pipe, plate spacers and base or
hold&3own plate that starts the venting from the top of furnace. See
Vent Installation on page 15 for additional items you will need.
Plaster Ground Kit 6905 - Used for 6901 or 6919 Rear
Outlet Registers.
Gas Conversion Kits - See page 17.
Thermostat - See page 20.