MAHLE ATX 280 FluidPRO Manual Del Usuario página 100

100
ATX 280
User Manual
14.2
ATF Refill / Injection
This mode allows only new oil to be injected into
the car's A/T circuit. The user is asked to enter:
Quantity of oil to be injected into the sys-
n
tem [l]
Fluid temperature for service startup [°C]
n
POSSIBLE ERROR MESSAGES
Too much pressure in the ATX ser-
vice station
14.3
ATF Recovery
This mode allows for the recovery of spent lu-
bricant from the automatic transmission system
only. You can perform:
Full recovery (automatic)
n
Partial recovery (manual)
n
Full recovery mode is shown by default.
Alternatively, using the numeric keypad you can
choose the amount of oil you want to recover.
Using the "Full Recovery" the station ATX 280 is
able to determine when all available oil has been
recovered.
Remember that under these condi-
tions the transmission may oper-
ate without the correct amount of
lubricant. An audible beep and an
on-screen message prompt the
user to turn off the vehicle's engine
as soon as possible.
To avoid damage to the automatic
transmission, the operator must
not leave the station unattended!
The operator must always be in a
position to take note of the sta-
tion's visual and audible signals
during operations.
POSSIBLE ERROR MESSAGES
Too much pressure in the ATX ser-
vice station
POSSIBLE ERROR MESSAGES
Fully drained vehicle A/T system