MAHLE ATX 280 FluidPRO Manual Del Usuario página 70

70
ATX 280
User Manual
Avoid inhaling ATF oils, additive
and protective fluids. Ensure good
room ventilation during use.
Electrical Connection:
only to a socket rated for the voltage indicated
on the nameplate located on the side of the
equipment. Always connect the power plug to a
grounded electrical outlet.
The maximum permissible impedance at the
point of connection to the mains must com-
ply with EN 61000-3-11. Inrush currents can
cause short voltage drops that can affect other
equipment under unfavorable conditions. If the
impedance at the point of connection to the
mains does not match, interference may occur,
therefore, consult your electric power company
before connecting the equipment.
Never operate the service station with a defec-
tive or different power cord. In case of damage,
have the cable replaced immediately with an
original or equivalent replacement by an author-
ized MAHLE service center. Before opening the
Connect the power cord
service station, pull the power cord completely
out of the plug, otherwise there is a risk of elec-
tric shock.
Do not manipulate or bypass safety devices
or their settings.
Do not leave equipment energized unless it is
to be used immediately, and disconnect power
before long periods of inactivity. Remember that
the (pressurized) equipment must be manned at
all times.
Lubricating oils and additives for automatic
transmissions - personal protective equip-
ment and precautions:
appropriate protective gear such as goggles,
gloves, and work-appropriate clothing. Contact
with automatic transmission fluids (such as ATF,
cleaners, and protectants) can cause irritation
and other physical harm to the operator.
Additional safety information can be obtained
from the safety data sheets of the manufacturers
of the lubricants and additives or protectants.
The operator must wear