MAHLE ATX 280 FluidPRO Manual Del Usuario página 87

9. Commissioning
9.1
Connections
Place the unit on a level and stable surface to
ensure proper operation.
It is then necessary to connect it to the mains
in accordance with the indications on the name-
plate of the unit located near the main switch,
especially regarding the applicable voltage and
power.
Positioning and electrical connection
Handling: In handling, it is necessary to have the
minimum equipment for proper handling as re-
quired by accident prevention regulations.
Placement:The equipment should be placed in
a stable location. Must be placed in a room with
adequate ventilation and/or air exchange. The
equipment should be placed at least 4 inches
(10 cm) away from any object that may impede
i
internal ventilation. Do not expose the equip-
ment to rain or excessive moisture, as this may
cause irreparable damage to the equipment. In
addition, the equipment should never be directly
exposed to sunlight or excessive dust.
Installation: Installation must be carried out by
specialized personnel, and the current national
electrical regulations must be strictly observed. It
is forbidden to use the equipment in an explosive
atmosphere.
Connections: Since this is an electronic device
connected to the mains, it is mandatory to use
the correct grounding on the power plug. Fail-
ure to use the ground connection could damage
the equipment and endanger the operator life.
Position the equipment so that the mains power
socket is easily accessible to the operator.
87