REDEX DRP+1 Manual De Usuario página 24

5.3 IF-type motor flange mounting (for in-line configurations DRP+M)
Respect the following instructions to install the motor flange.
1. Clean the mounting surfaces to be fitted together. Pay special attention to the motor shaft and the
gearbox input split bore.
2. Rotate the clamping hub in order to bring the screws in front of their radial holes. Rotate the input
split-bore of the gearbox in order to align the split bore groove with the clamping hub groove as
shown in the sketch below.
a.
When the clamping hub bore is bigger than the
diameter of the motor shaft, a shaft adapter is
supplied with the unit. The groove of this
adapter must be aligned with the split bore.
Surfaces to be cleaned
Clamping
screws hole
Clamping
screws
Clamping hub
Gearbox input
split-bore
Motor flange
In case of a cylindrical shaft
Clamping hub
Adapter
This document must not be reproduced nor information therein disclosed without our authorization
DRP+ User manual
A shaft adapter (taper -> cylindrical) is
supplied with the unit. Tighten the motor shaft
Version 01/2017 - English
b. In case of a taper shaft
nut after installing the adapter.
Adapter
Ref.: RX182/009
Page 22 / 30